Home User GuideHOW TO INSTALL LED SEMI CUT OFF WALL PACK
HOW TO INSTALL LED SEMI CUT OFF WALL PACK

HOW TO INSTALL LED SEMI CUT OFF WALL PACK

Share

Please Read All Instructions Attempting Installation

-To prevent personal injury or product damage only licensed electricians should install.

-To avoid electric shock or component damage disconnect power before attempting installation or servicing.

-This product must be installed in accordance with the national electric code(NEC) and applicable federal, state and local electric codes and safety standards.

-Disconnect product and allow cooling prior to servicing.

-Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.

-To prevent product malfunction and/or electric shock this product must be properly grounded.

-This luminaire is designed to operate in ambient temperatures ranging from -30℃ to 45℃ and to be horizontally mounted with the LEDs facing down.

-Wall mount only.


Unpacking

Thoroughly inspect the fixture for freight damage. Freight damage should be reported to the delivery carrier.


Installation

1).Take off the screw of the heat sink and take off the front lid carefully from the back. The angle between the front cap and the back cap should be 0-45 degrees.

install led wall pack

2).A: After determining a place to put a conductor, take off the 1/2” cap and make a hole according to the example(B). Fix it on the wall with an appropriate screw.(Please use glue to block the hole to prevent water leakage.)

B: When installing the junction box, take off the 1/2” cap of the C wire in the middle. This product supports standard 3 1/4” and 4” junction box. After installing the back cap on the wall, use waterproof sealer to seal it.

install led wall pack light 2

3).Link A wire and C wire (The black one is L, white one is N, and the yellow one is groud wire), installing the front cap.

led wall pack link a wire

4). Make sure the wires are all linked rightly, and lock up with the screw.

how to install led wall pack light


Installation of the photocell

Photocell input voltage range 120V or 277V, 60HZ,

1).Pick a 1/2” cap of either side of the product and install the photocell according to the picture.

led wall pack light installation of the photocell

2).Complete the photocell system after installing the photocell.

led wall pack light installation of the photocell 2

  1. Checking
  • Are the wired linked in a right way as the picture shows?
  • Is the ground lead installed appropriately?
  • Make sure the photocell function well.

Shop LED Wall Pack Light at https://www.lightingever.com/led-wall-pack-lights

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.